WA electrician, company fined $32,500 for safety breach


Monday, 29 November, 2021

WA electrician, company fined $32,500 for safety breach

Balcatta electrical company Sampson Electrical Contractors Pty Ltd (EC8976) and electrical worker Milan Jakovljevic (EW178929) have been fined a combined $32,500 after pleading guilty to breaching Western Australia’s electrical licensing regulations, following a prosecution by Building and Energy. Jakovljevic was working for Sampson Electrical Contractors when he installed a switchboard in September 2019 to supply power to a property. Jakovljevic’s failure to install a key safety component and carry out mandatory tests left the property unprotected against electrical hazards for a week. During onsite tests a week after Jakovljevic’s work, a Western Power inspector discovered the switchboard had no multiple earthed neutral (MEN), a key component of the protection system.

Without an MEN, protective devices such as circuit breakers and fuses may not operate if an electrical fault occurs, which can cause metal objects to become live with dangerous levels of electricity. The buildings were closed off until an MEN was fitted and the switchboard passed all safety tests.

Describing the breach as serious, Magistrate Colin Roberts fined Jakovljevic $7500 for the non-compliant installation and Sampson Electrical Contractors $25,000 for submitting a notice that incorrectly declared the work was checked, tested and complied with the electrical licensing regulations. Each party was also ordered to pay costs of $348.50. WA’s Director of Energy Safety, Saj Abdoolakhan, said other failures to install MENs had cost the lives of at least two WA children in recent decades and had led to several electric shocks and close calls. Abdoolakhan added that there is no excuse for cutting corners with any area of electrical work when people’s lives are at risk.

“In this case, the consequences could have been devastating if a fault had occurred while there was inadequate protection against electrocution. By law, electricians are required to undertake their own testing and verifications when they work on electrical installations. Had the electrician done his due diligence, he would have easily identified this serious defect. The company then falsely declared that the electrical work was checked, tested and complied with the regulations, when it obviously did not,” Abdoolakhan said.

Image credit: ©stock.adobe.com/au/Eakrin

Related News

Power station charged over workplace arc flash death

A Yallourn power station has been charged with breaching the Occupational Health and Safety Act...

Plumbers fined for unlicensed electrical advice

Two plumbers employed by a large Perth plumbing, gas and electrical company have been fined for...

SafeWork NSW commences solar farm safety blitz

SafeWork NSW will inspect solar farms in operation and under construction, as part of a safety...


  • All content Copyright © 2022 Westwick-Farrow Pty Ltd