30-tonne concrete wall collapse that injured mother and child lands $150K fine


Tuesday, 17 November, 2026

30-tonne concrete wall collapse that injured mother and child lands $150K fine

The principal contractor for the construction of a three-storey residential development which incorporated 10-metre-high precast concrete wall panels weighing multiple tonnes has been fined $150,000 after a 30-tonne precast concrete wall collapsed onto a neighbouring property, injuring a mother and child and, SafeWork SA said, exposing workers and members of the public to the risk of death or serious injury.

Convicted in the South Australian Employment Court on 5 November 2026 following a SafeWork SA investigation, following an incident at a residential construction site in Wayville in November 2023, the company pleaded guilty to a Category 2 offence under the Work Health and Safety Act 2012.

The precast concrete wall panels were temporarily supported by propping until they could be safely incorporated into the permanent structure. Because it was restricting access to parts of the construction site, the company requested the removal of the temporary propping in November 2023. Despite no engineer certifying it was safe to do so, the propping was removed on 15 November 2023.

The wall remained unsupported for 13 days before three precast panels collapsed outward onto the neighbouring property on 28 November 2023. With the fallen section of wall weighing about 30 tonnes, the collapse caused significant damage to the neighbouring home, injuring a mother and young child.

The child sustained superficial cuts while the mother required stitches to a knee injury. The company failed to ensure the propping was only removed when it was safe to do so and failed to obtain engineering certification before the removal, as required under the relevant Australian Standard, the SafeWork SA investigation found.

During the investigation, expert evidence obtained concluded the collapse was caused by the premature removal of the propping before an adequate lateral bracing system had been installed. The wall was found by the expert to lack sufficient support to withstand even moderate wind loads and that a competent engineer would not have approved removal of the props at that stage of construction.

“This incident demonstrates the potentially catastrophic consequences of removing critical safety controls without first obtaining expert advice and approval,” SafeWork SA Executive Director Glenn Farrell said. “Precast concrete panels can weigh many tonnes and present obvious risks to workers and members of the public if they are not adequately supported throughout construction.

“Builders and principal contractors cannot assume others have assessed and managed critical structural risks. They must ensure the appropriate engineering assessments, certifications and approvals are obtained before making decisions that affect safety.

“The collapse of this wall could easily have resulted in fatalities. This prosecution should serve as a reminder that duty holders must understand and comply with the standards and safety requirements that apply to the work they undertake.”

Deputy President Stephen Lieschke said in his sentencing remarks that the company failed to take the mandated and reasonably practicable safety measure of obtaining a qualified engineer’s assessment and approval before removing the propping. Lieschke said the company knew no engineer had approved removing the propping and described its failure to obtain professional assessment and approval as a “stark failure” to control an obvious risk of extremely serious harm.

After applying a 40% reduction for the company’s early guilty plea and demonstrated contrition, the court imposed a fine of $150,000. The company was also ordered to pay a Victims of Crime levy of $451 and SafeWork SA’s legal costs of $1210.

Image credit: iStock.com/ottoblotto. Stock image used is for illustrative purposes only.

Related News

WHS impacts of climate change — development of a national strategy announced

The announcement from Safe Work Australia follows the release of the Best Practice Review of the...

National Safe Work Month calls for action in its final week

As National Safe Work Month draws to a close for 2026, this week's theme encourages...

National Safe Work Month looks to the future in Week 3

The week three theme of National Safe Work Month encourages workplaces to consider how...


  • All content Copyright © 2026 Westwick-Farrow Pty Ltd